Eugene RC Aeronauts

I was having trouble with my Funtana S .90 3D with Thunder Tiger 120 Pro. It was not running very well and getting worse. I took off the cowl and pulled the head. What I found was the head screws were not very tight. And the head gasket was squirting out of the groove. I have since ordered a new gasket kit ($4.50)

Well I'll be a son ova gun!

Bearings going out on my DLE 20 this week.. So, being Melissa will be wanting that motor to run a long time, I ordered a new set of Boca bearings, Bowman piston ring, and a new true Walbro carb If all go's right, that thing should be pretty impressive

Did you get that thing running good again, Dwayne?

Yes, it is running fine now. I won’t be out for a while. I’m going on vacation for about a month. I’ll be back the first week of July, see you then.